Problems and Possible Improvements

List of known software/hardware problems, bugs and ideas for further improvements.

Problems and bugs to solve

Changing the gain in high-frequency mode

You may be surprised when reconfiguring the gain in high-frequency mode: the number you set will not be the one reflected in the ROS2 parameter. This is what the SonarDriver source code of the low-level oculus_driver_lib states:

// When masterMode = 2, the sonar force gainPercent between 40% and
// 100%, BUT still needs requested gainPercent to be between 0%
// and 100%. (If you request a gainPercent=0 in masterMode=2, the
// fireMessage in the ping results will be 40%). The gainPercent is
// rescaled here to ensure consistent parameter handling on client
// side).
if(newConfig.masterMode == 2) {
    newConfig.gainPercent = (newConfig.gainPercent - 40.0) * 100.0 / 60.0;
}

As you can see, a proper value rescaling is performed when sending the request to the sonar. The behavior without this rescaling has not been tested yet.

Reconfiguring the sensor publish rate

From the last tests, the sensor publish rate looks limited to a maximum of 7 fps, even when reconfiguring it to a higher rate. This is a relevant problem that must be solved to operate the sonar efficiently in the field.

Running sonar + IP camera

When the sonar and an IP camera (Sony) run simultaneously, they seem to overload the Ethernet communication, and multiple sonar frames are lost periodically. This is a relevant issue to address in order to deploy both camera and sonar in the field.

To test

Sonar + USB camera

Does the same problem as with the IP camera occur?

To do and ideas

Implement robust sonar image filtering

Before implementing any perception algorithm, it is mandatory to find optimal ways to filter as much noise as possible from the sonar data. Artifacts and speckle noise will influence and degrade the performance of any computer vision and deep learning technique.

Ensure bandwidth

Ensure that the communication can work at 10 Mbps and not only at 100 Mbps. ROS2 provides a CLI tool for this:

ros2 topic bw /your/topic_name

By default, this tool outputs the data rate in MB/s (megabytes per second). Multiply by 8 to get Mbps.